The hulls of the Dart 18 are similar to most sailing catamarans, but without centreboards. Instead, the lower part of the hulls have skegs typical for a beach catamaran. The hull material is glassfibre. Both hulls are filled with flotation inserts to preserve buoyancy in case of damage. The inside of each hull can be reached through a hatch cover located at the rear of each hull. The boat is assembled by attaching the main and rear beams to the hulls with spring-loaded retaining clips, and lacing the trampoline to the beams and hulls. The two rudders are removable without tools, retract on impact with the beach, and can be locked in the up position.
The rigging consists of a rotating mast held by a forestay and two shroud wires. The shrouds can be adjusted by simply moving the bolts in the chainplates. The Dart 18 mast does not have spreaders. There is a trapeze for the crew.
The mainsail does not have a boom, has nine full battens, and is controlled by a main sheet with a 7:1 mechanical advantage. The jib sail has two short battens, and is controlled by a jib sheet with a 2:1 mechanical advantage. The main sheet block and both jib sheet blocks have a ratchet and a cleat.
A gennaker sail can be added, but is not legal for racing. This is usually combined with a jib furling system. The boat can also be sailed by one person, without a foresail, with a D-PN of 78.7.
Build / Config
Ratings / Handicaps
Number of crew
Sail area (total)
Main sail area